Frequency: 50/60Hz Model: E-20W
Performance Features:

1. This product uses high-tech ceramic PTC thermistors.

As a heating element, it heats up quickly.

PTC thermal sensitive resistor for automatic temperature control,

When the temperature rises to the design temperature of the glue gun, it will no longer increase.

Can prevent the damage caused by the overheating of the heating element to the glue gun.

Save energy consumption to achieve the purpose of extending service life.

2. The electrical insulation strength of this product does not break under 3750V/minute.

It can be used normally in an AC or DC power supply between 100V and 240V.

Unrestricted by voltage fluctuations, with built-in safety fuse, use is safer.

Product Application:

1. Toy models.

2. Artificial flowers, Christmas trees.

3. Decorative items, metal products.

Wooden products, cardboard, etc.

5. Electronic circuit board.

Usage Method:

1. This series of products can be used for rubber strips with a diameter of 7-7.5MM.

2. Insert the adhesive tape into the adhesive gun at the end, and send it to the gun tube. Plug in the power and preheat for 5-8 minutes,

Press the plunger to eject the melted glue, and the amount of glue can be controlled.

3. During use, if a whole rubber band cannot be used at one time, do not remove it.

You can plug in the power and preheat for 5-8 minutes before using it next time.

All products are produced by large enterprises, with stable performance, convenience of use, and simple operation.single
注意事项：
1. The use of voltage 100-240V, frequency 50-60Hz.
2. This product is a high-temperature glue gun, and it should be used with the corresponding size of the glue tape according to the product series.If the user uses a size or type of adhesive tape that does not match, it may cause the sol to reflux and damage the adhesive gun.
3. When using the glue gun, the hot nozzle and melting adhesive can be very hot, so please do not touch it with your hands; Do not use it in places with flammable and explosive materials.
4. When using a glue gun, do not lift it high, and the nozzle should not face up; if you do not use glue for 15 consecutive minutes, please turn off the power to prevent the glue from melting backward and damaging the glue gun.
5. Due to the addition of durable materials in the glue gun, there may be smoke emitted upon initial use. After 30 minutes of use, the smoke will automatically dissipate.
6. It is necessary to maintain the gun tail block clean to ensure that the seal can be smoothly inserted into the barrel.
7. Do not pull the glue tape out of the glue gun from the rear.
8. When the glue gun is not in use, it should be placed in a well-ventilated and dry place. It is prohibited to place it in a place with moisture or water. It is also prohibited to place it in a place where children or children can reach.
9. This tool must be placed on its stand when not in use.
10. Please do not replace the power cord without authorization. Only personnel who meet the relevant requirements of electrical and electrical product maintenance are allowed to replace it.