：

1, before the hot melt glue gun plugged in, please first check whether the power cord is in good condition, stands ready to; have used glue gun glue and so on.

2, 3-5-minute warm-up before you glue gun use, glue gun when not in use, please stick to the desktop.

3, please keep the hot melt Adhesive surface is cleaned to prevent impurities plug the gun nozzle.

4, glue gun during use if no adhesive, check if the glue gun fever;

If the glue gun is not a normal fever cases, reasons might be:

1 plug the glue gun is not good;

2 glue guns due to a short circuit and burn.

Glue guns under normal conditions of heating, causes may be:

1 gun with a muzzle because impurities block the plastic outlet, professional treatment;

2 glue gun glue and tape thicker, just rotate the strips gently and carefully pull back a small part of a week, pulling off the tape thicker part before continuing use.

5, to avoid use in a damp environment-melt gun suppression, humidity can affect the insulating properties, may result in electric shock.

6, nozzle and melt very high temperatures (about 200 degrees) except the shank, but cannot gain access to other sections.

7, do not pull out into the plastic Outlet Strip, hot-melt glue can cause severe burns or damaged glue guns.

8, do not disassemble the parts and installation of heating, otherwise it will lead to failure.

9, do not allow children to touch, and deposited outside of her exposure.

10, in addition to melt, but not for any other purpose.

11, glue gun glue when backflow occurs, please discontinue use immediately until the professionals clean finished back in hot melt Adhesive before use.

12, the glue gun heats more than 15 consecutive minutes without, please cut off the power supply.