Chat
Honor-Mcn80 Pneumatic Tools Pneumatic Nail Gun Riveting Gun
| Packaging information: |
|
|---|
Pneumatic nail gun MCN80
F nail can be up to 5mm, gun volume 362*132*307,mm,4KG
300-350PCs (1.55mm-50mm can be put on)
instructions for use:
1. This staple gun is used for wooden filament plate, old wood, building templates and other wood recycling operations.
2. Before use, drop a little lubricating oil from the pipe joint, and the pipe joint is connected with compressed air.
3. It is suitable for pushing and unloading of a single nail and fixing various connections without or restricting continuous nailing.
Note:
1. Only compressed air can be used, and the working pressure must not exceed 0.8MPa;
2. It is strictly forbidden to use flammable and explosive gases such as oxygen, and it is strictly forbidden to use high-pressure air compressor as the power source;
3. Before use, make sure that the pressure gauge of the air compressor is correct and reliable, so as to avoid damage caused by over-pressure use;
4. Wear goggles and protective gloves when using staple gun to ensure the safety of operators;
5. When nailing, remove the air connector and cut off the air source;
6. It is strictly forbidden to point the gun head to yourself or others to avoid causing harm;
7. During operation, it is strictly prohibited to be close to flammable and explosive products, and do not work in harsh environments such as corrosion, corrosion and dust;
8. Don't knock and touch at will, don't empty the gun at will;
9. If a fault occurs, disconnect the air source immediately, take out all the nails in the clip and repair it.
300-350PCs
