502Glue isAlpha.-ethyl cyanoacrylate is mainly used, and adhesion agent, stabilizer, toughening agent,The polymerization retarder, etc.The single component is solidified instantly by advanced production processadhesive.

Method of use

1After cleaning the surface, remove the dust, oil, rust and so on, next to the metal, the best first grinding rough, rightPE,pporPTEEPlastic, such as the surface should be activated.

2Open the front cover and tap the tip with your fingers so that no residual liquid is left, then cut the hole with scissors.

3A small drop of the reagent on the followed surface shall be immediately followed, and shall remain until hardened, and then the area shall not be too large, and then the thickness of the layer shall not exceedThe 0.2 mm.

4Wipe the container after use and put the lid on. Store in a cool and dry place or refrigerate.

Matters needing attention

1Vapors from the agent can irritate mucous membranes and eyes.

2Avoid contact with skin and eyes. If accidental, wash with plenty of water and send to doctor immediately. Use dilute sodium bicarbonate solution when cleaning eyes.

3When touching hands, wash with soap, water, cleaning solution and pumice stone

Remove method

1, can use wet hot towel to stick502There. Solidified after ten minutes502It's going to be soft, and it's going to be cleared.

Solutions of the glue

And you can have them502One more drop in the area502solidified502It's going to be soft, and you can get rid of it with a towel.

2Drop it in its place502Make the original502Melt, then quickly rinse off.

3Use insulating oil. Pour the insulating oil on the transformer on the table.502The glue quickly softens and can be quickly rubbed off.