1. Surface cleaning. The paste surface must be kept absolutely clean and dry. Generally, cloth without fiber shedding can be dipped in 50% alcohol, isopropyl alcohol, acetone or toluene solution for cleaning, the surface cleaned by solvent shall not be pasted until the solvent is thoroughly used.

2. Paste the product. Before pasting the product, adjust the product at the required installation position. After confirming the installation position of the product, tear off the red film and paste it. Avoid contact between fingers and the adhesive surface during operation, and press the product with force after pasting to ensure full contact with the adhesive surface HR wet.

3. After the product and parts are pasted, it takes 24 hours to avoid contact with water and large dust to achieve better adhesion.

Please choose to install on sunny days. Before installation, be sure to clean the paste position thoroughly with detergent and press it tightly for a period of time. Do not wash the car within 2 days. If it is colder, please use a hair dryer to slightly bake it to keep the gum soft and sticky.