Contact online customer service or call TEL: 18868554531 QQ: 2760179072 learn more about styles factory Direct sales support customization

size 0.53*9.5 m need to brush glue glue to buy another one

the colorful wallpaper decoration effect is very obvious, which can make the room into a variety of atmosphere, and the cost is relatively friendly. What is the process of wallpaper installation and pasting,

wallpaper installation steps

there is also a process for installing wallpaper, which generally includes five steps,

1. First of all, clean the base layer and fill the gap. Joint band and Putty should be attached to the joint of gypsum board surface;

2. Puttying grinding. When handling at the grassroots level, it must be cleaned, smooth and smooth;

3. Apply desiccant, moisture-proof paint should be applied evenly, not too thick;

4. Paper cutting and gluing, and vertical lines can be used to mark the width of wallpaper on the wall;

5. Paste, splice and lap the wall, stick the wallpaper on the wall, align the edges, roll out the wall with rubber roll, press adhesive bubbles; Trim, use wallpaper knife to roll the ceiling, cut off the excess wallpaper in wainscot and windows, and wipe the glue.

Step wallpaper:

1. When you are wallpaper, the first thing to do is to use a scraper to flatten the wall surface, clean up the falling Wall skin, and then remove the dirt on the wall surface to keep the wall surface flat and clean.

2. After the wall surface is cleaned and leveled, we need to evenly draw a groove mark on the wall surface with a scraper. The Groove mark can allow wallpaper agent to quickly penetrate into the wall surface.

3. After finishing the groove marks infiltrated by the auxiliary wallpaper agent on the wall, you can start to apply wallpaper agent on the wall. When applying wallpaper agent, you must pay attention to the uniform application.

4. After the wallpaper is evenly applied to the wall, you need to wait about five minutes before it can be wallpaper on it. In this time, we can prepare wallpaper and cut the wallpaper according to the actual size of the wall.

5. After the wallpaper is cut, you can start to paste it on the wall. We must pay attention to it when we are wallpaper. It is best to face mask from the top, such a layer-by-layer sticker. Also pay attention to the place where the corner must be firmly pasted, and there should be no gap.

6. It is inevitable that foaming will occur at wallpaper. If foaming is not eliminated in time, the wallpaper will easily fall off, all we need to do is use a needle to puncture the wallpaper with bubbles and then flatten the wallpaper..